Mitsubishi Outlander: Cancelling the system
The following methods can be used to cancel the system when it is in the system preparation mode or the system armed mode.
► Pressing the UNLOCK switch on the remote control switch.
► Turning the ignition switch to the “ON” position.
► Opening any of the doors or the rear hatch, or inserting the key into the ignition
switch when the system is in the system preparation mode.
► Holding the keyless operation key and pressing the driver’s and front passenger’s
door lock/unlock switch, or the rear hatch OPEN switch to unlock the doors and rear
hatch (vehicles with the keyless operation system).
Note
► If the bonnet is opened during the system preparation mode, the system preparation
mode is suspended.
The system returns to the system preparation mode when the bonnet is closed.
► If the battery terminals are disconnected while the system is in the system preparation
mode, the memory will be erased.
► It is possible to register up to 8 remote control switches for the keyless entry
system and 4 remote control switches for the keyless operation system.
As long as they are registered, any of the remote control switches, other than the
one used to activate the system, can be used to cancel the system.
If you want to register additional remote control switches, please contact a MITSUBISHI
MOTORS Authorized Service Point.
► The activation distance for the keyless entry system is approximately 4 m.
If it is not possible to lock or unlock the vehicle by pressing the switch at the
correct distance or the security alarm system cannot be set or cancelled using the
switch, the battery may need to be replaced.
Replace the battery at a MITSUBISHI MOTORS Authorized Service Point.
► If the UNLOCK switch on the remote control switch, or the driver’s or front passenger’s
door lock/unlock switch is pressed and no door or the rear hatch is opened within
30 seconds, the doors or the rear hatch will automatically relock. In this case
as well, the system preparation mode will go into effect.
► The time between pressing the UNLOCK switch on the remote control switch, or the
driver’s or front passenger’s door lock/unlock switch and automatic locking can
be adjusted.
Consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations
can be used to make the adjustment.
Refer to the separate owner’s manual for details.
READ NEXT:
Alarm activation
When the system is in the system armed mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the doors, rear hatch or bonnet is opened
using a method other than the
Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
► Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle
Electric window control
The electric windows can only be operated with the ignition switch in the “ON”
position.
SEE MORE:
Important operation tips for air conditioning
(1) Park the vehicle in the shade. Parking in the hot sun will make the vehicle
interior extremely hot, and it will require more to cool the interior. If it is
necessary to park in the sun, open the windows for the first few minutes of air
conditioning operation to expel the hot air. (2) Close
To remove
1. Wrap the tip of the bar with a cloth, insert it deeply into the notch provided
in the wheel cover, and use it to lever up the cover a little.
2. With the cover raised a little, pry it off completely using the jack bar.
Insert the jack bar under the cover, and move it around the circumferen
