Mitsubishi Outlander: Setting the system

Follow the procedure below to set the system to the system armed mode.

1. Turn the ignition switch to the “LOCK” position.

If you started the engine with the key, remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors, rear hatch and bonnet.
3. Press the LOCK switch (A) on the remote control switch of the keyless entry system or the keyless operation system, the driver’s or front passenger’s door lock/unlock switch (B), or the rear hatch LOCK switch (C) in order to lock all the doors and rear hatch.

By locking the vehicle using the keyless entry system or the keyless operation function, the system preparation mode is activated.

The security indicator (D) in the audio panel blinks for confirmation.

Note

► The system preparation mode is not activated when the doors and rear hatch have been locked using a method other than the keyless entry system or the keyless operation function (namely a key, the inside lock knob or the central door lock switch).
► If the bonnet is open, the security indicator illuminates, and the system does not enter the system armed mode.
When the bonnet is closed, the system enters the system preparation mode, and after approximately 20 seconds the system enters the system armed mode.

4. After approximately 20 seconds, the buzzer stops, and when the blinking of the security indicator starts to slow down, the system armed mode goes into effect.

The security indicator continues to blink during the system armed mode.

Note

► The security alarm system can be activated when people are riding inside the vehicle or when the windows are open. To prevent accidental activation of the alarm, do not set the system to the system armed mode while people are riding in the vehicle.
► Avoid leaving valuable items inside the vehicle even when the security alarm system has been set to the “active” mode.

To deactivate the vehicle inclination detection function and the interior intrusion detection function

The vehicle inclination detection function and the interior intrusion detection function can be deactivated when parking in automated car parks, when leaving pets in the vehicle or when leaving the vehicle with the windows slightly open.

1. Turn the ignition switch to the “LOCK” position.

If you started the engine with the key, remove the key from the ignition switch.
2. Raise and hold the wiper and washer switch to the “MIST” position for approximately 3 seconds. The buzzer will sound once and the function will be deactivated.

To activate the function again, raise and hold the wiper and washer switch to the “MIST” position for approximately 3 seconds.

The buzzer will sound twice and the function will be activated.

Note

► The function will be activated again if the following operation is performed.

• If the doors and rear hatch are unlocked using the keyless entry system or the keyless operation function.
• If the ignition switch is turned to the “ON” or “ACC” position.

READ NEXT: