Mitsubishi Outlander: Steering wheel lock
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Locking and unlocking / Keyless operation system / To turn from “ACC” to “LOCK” / Steering wheel lock
To lock
Turn the emergency key to the “LOCK” position.
Turn the steering wheel until it is locked.
To unlock
Turn the emergency key to the “ACC” position while moving the steering wheel slightly right and left.
Caution
► Remove the emergency key when leaving the vehicle.
In some countries, it is prohibited to leave the key in the vehicle when parked.
READ NEXT:
Starting
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
υ
Starting the engine (diesel-powered vehicles)
1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
Note
► On vehicles with the Auto Stop & Go (
SEE MORE:
Ignition switch
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Ignition switch” on pages 1-11 and 1-18.
[Except for vehicles equipped with keyless operation system]
LOCK
The
Selector lever operation
The CVT selects an optimum gear ratio automatically, depending on the speed of
the vehicle and the position of the accelerator pedal.
The selector lever (A) has 2 gates; the main gate (B) and the manual gate (C).
Warning
► Always depress the brake pedal when shifting the selector lev
© 2010-2026 Copyright www.mioutlander.com
