Mitsubishi Outlander: Starting the engine (diesel-powered vehicles)
1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
Note
► On vehicles with the Auto Stop & Go (AS&G) system, the starter will not operate unless the clutch pedal is fully depressed (Clutch interlock).
5. Place the gearshift lever in the “N” (Neutral) position.
6. While pushing the lock release button (A), remove the cover of the ignition switch.
7. Insert the emergency key into the ignition switch.
8. Insert the keyless operation key into the emergency key.
9. Turn the emergency key with keyless operation key to the “ON” position. The diesel preheat indication lamp will first illuminate, and then after a short time go out, indicating that preheating is completed.
Note
► If the engine is cold, the diesel preheat indication lamp is on for a longer time.
► When the engine has not been started within about 5 seconds after the diesel preheat indication lamp went out, return the ignition key to the “LOCK” position. Then, turn the emergency key to the “ON” position to preheat the engine again.
► When the engine is warm, the diesel preheat indication lamp does not come on even if the emergency key is placed in the “ON” position.
Start the engine by turning the emergency key right to the “START” position.
10. Turn the emergency key with the keyless operation key to the “START” position without depressing the accelerator pedal, and release it when the engine starts.
Note
► Minor noises may be heard on engine startup.
These will disappear as the engine warms up.
READ NEXT:
Using the MIVEC engine
The MIVEC engine automatically controls valve timing in accordance with driving
conditions for maximum engine performance.
Note
► To protect the engine, the high-speed mode may not be selec
Keyless entry system
Press the remote control switch, and all doors and the rear hatch will be locked
or unlocked as desired.
It is also possible to operate the door outside rear-view mirrors.
1- LOCK switch
2- UN
To lock
Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal
lamps will blink once.
Note
► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1
SEE MORE:
Cup holder
CAUTION
• Do not drink beverages while driving.
This is distracting and could cause an accident.
For the front seat
The cup holders are located in front of the floor console box.
For the rear seat
In order to use the cup holder, allow the armrest (A) to drop down.
Safety mechanism
If a hand or head is trapped in a closing window, the window glass will lower
automatically.
Please ensure that nobody puts their head or hand out the window when closing.
The lowered window will become operational after a few seconds.
CAUTION
The safety mechanism is cancelled just before the
