Mitsubishi Outlander: To turn from “ACC” to “LOCK”
1. [Vehicles equipped with M/T]
Push the emergency key in at the “ACC” position and keep it depressed until it is turned to the “LOCK” position, and remove it.
[Vehicles equipped with CVT or Twin Clutch SST]
First, set the selector lever (CVT) or the gearshift lever (Twin Clutch SST) to the “P” (PARK) position, and then push the emergency key in at the “ACC” position and keep it depressed until it is turned to the “LOCK” position, and remove.
2. Install the cover of the ignition switch.
3. Reinsert the emergency key into the keyless operation key.
Note
► Vehicles equipped with CVT or Twin Clutch SST, the emergency key cannot be removed unless the selector lever (CVT) or the gearshift lever (Twin Clutch SST) is set to the “P” (PARK) position.
► When not using the emergency key, always install the ignition switch cover. Otherwise, there is a danger of dirt or dust getting into the keyhole of the ignition switch and causing a malfunction.
Caution
► Do not remove the emergency key from the ignition switch while driving.
The steering wheel will be locked, causing loss of control.
► If the engine is stopped while driving, the brake servomechanism will cease
to function and braking efficiency will deteriorate.
Also, the power steering system will not function and it will require greater manual
effort to operate the steering.
► Do not leave the ignition switch in the “ON” or “ACC” position for a long time
when the engine is not running, doing so will cause the battery to be discharged.
► Do not turn the ignition switch to the “START” position when the engine is running,
doing so could damage the starter motor.
- Steering wheel lock
- Starting
- Starting the engine (petrol-powered vehicles)
- Starting the engine (diesel-powered vehicles)
READ NEXT:
Steering wheel lock
To lock
Turn the emergency key to the “LOCK” position.
Turn the steering wheel until it is locked.
To unlock
Turn the emergency key to the “ACC” position while moving the steering wheel
Starting
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
υ
SEE MORE:
Head restraints
WARNING
• Driving without the head restraints in place can cause you and your passengers
serious injury or death in an accident. To reduce the risk of injury in an accident,
always make sure the head restraints are installed and properly positioned when
the seat is occupied.
• Never pla
Towing the vehicle by a tow truck
CAUTION
(1) This vehicle cannot be towed by a tow truck using Type A equipment
to prevent the bumper from deformation. If this vehicle is towed, use Type B, Type
C, Type D or Type E equipment. (2) In case the vehicle with automatic transmission
must be towed farther than 30 km, transport the
