Mitsubishi Outlander: Alarm activation
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Locking and unlocking / Security alarm system / The security alarm has four modes / Alarm activation
The turn-signal lamps blink and the siren sounds for approximately 30 seconds. Refer to “Alarm activation”.
Note
► The alarm will resume if unlawful actions are taken again, even if the alarm has stopped.
READ NEXT:
System cancellation
It is possible to cancel the system activation during the system preparation
mode or the system armed mode.
In addition, it is possible to cancel the alarm once it has been activated.
Refer to “
Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Turn the ignition switch to the “LOCK” position.
If you started the engi
Setting the system
Follow the procedure below to set the system to the system armed mode.
1. Turn the ignition switch to the “LOCK” position.
If you started the engine with the key, remove the key from the ignitio
SEE MORE:
Modification/alterations to the electrical orfuel systems
MITSUBISHI MOTORS CORPORATION has always manufactured safe, high quality vehicles.
In order to maintain this safety and quality, it is important that any accessory
that is to be fitted, or any modifications carried out which involve the electrical
or fuel systems, should be carried out in acco
To unlock the doors and rear hatch
You can select the function to unlock the doors and rear hatch either using the
ignition switch position or using the selector lever position (CVT) or the gearshift
lever position (Twin Clutch SST).
These functions are not activated when the vehicle is shipped from the factory.
To activate or
© 2010-2026 Copyright www.mioutlander.com
