Mitsubishi Outlander manuals

Mitsubishi Outlander: System cancellation

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Locking and unlocking / Security alarm system / The security alarm has four modes / System cancellation

It is possible to cancel the system activation during the system preparation mode or the system armed mode.

In addition, it is possible to cancel the alarm once it has been activated.

Refer to “Cancelling the system”, “Cancelling the alarm”.

► When lending the vehicle to another person or allowing the vehicle to be driven Note

► When lending the vehicle to another person or allowing the vehicle to be driven by someone who is unfamiliar with the security alarm system, be sure to give the person a proper explanation of the security alarm system.

If a person who is unfamiliar with the security alarm system accidentally unlocked the vehicle, causing the alarm to sound, the alarm would be a nuisance to people nearby.

READ NEXT:

 Changing the security alarm settings

It is possible to set the security alarm to the “active” mode or “inactive” mode. Follow the procedure below. 1. Turn the ignition switch to the “LOCK” position. If you started the engi

 Setting the system

Follow the procedure below to set the system to the system armed mode. 1. Turn the ignition switch to the “LOCK” position. If you started the engine with the key, remove the key from the ignitio

 Cancelling the system

The following methods can be used to cancel the system when it is in the system preparation mode or the system armed mode. ► Pressing the UNLOCK switch on the remote control switch. ►

SEE MORE:

 Control panel

A- Temperature control dial B- Air selection switch C- Blower speed selection dial D- Air conditioning switch E- Mode selection dial F- Rear window demister switch Note ► There is an interior air temperature sensor (G) in the illustrated position. Never place anything on top of the

 Auto reset mode

► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset. ► If the ignition switch is at “ACC” or “LOCK” for about 4 hours or longer, the average speed display is automatically reset.

© 2010-2025 Copyright www.mioutlander.com