Mitsubishi Outlander: ACD control mode display

Example: “TARMAC” mode is selected.
The currently selected control mode is displayed on the multi-information display.
In addition, when the control mode is changed, the selected mode appears on the
interrupt display screen of the information screen in the multi-information display.
The control mode display will appear on the information screen for a few seconds,
and then the original screen will return.
Caution
► The ACD control mode display may flash under aggressive driving conditions.
At this time, ACD control is temporarily suspended in order to protect the ACD device,
but this will not affect normal driving.
After the vehicle is driven for a while, if the ACD control mode display remains
on, the ACD control will start operating again.
READ NEXT:
When there is a malfunction in the system, the warning display will appear on
the information screen in the multi-information display.
In addition, the ACD control mode display in section (A) will
A limited-slip differential (LSD) is applied for the rear wheel differential.
The features of this LSD are described below: Just as with a conventional differential,
the wheel on one side is allow
All the parts of the brake system are critical to safety.
We recommend you to have the vehicle checked at regular intervals according to
the service booklet.
Caution
► Avoid driving habits
SEE MORE:
To check the coolant level
A transparent coolant reserve tank (A) is located in the engine compartment.
The coolant level in this tank should be kept between the “LOW” and “FULL” marks
when measured while the engine is cold.
To add coolant
Petrol-powered vehicles
The cooling system
The detection areas of the corner and back sensors are limited to those shown
in the illustration. Moreover, the sensors are unable to detect low or thin objects
or objects near the rear bumper. Thus, make sure to check the surroundings as you
operate the vehicle in a safe manner.
Corner and
© 2010-2025 Copyright www.mioutlander.com
