Mitsubishi Outlander: Active Stability Control (ASC) OFF display screen*
Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Instruments and controls / Multi-information display / Active Stability Control (ASC) OFF display screen*
This is displayed when the Active Stability Control (ASC) is turned off with the ASC OFF switch.
If there is a fault with the ASC, the ASC OFF display is shown.
Refer to ““ASC OFF” switch”.
READ NEXT:
Information screen (when the ignition switch or the operation mode is ON)
Each time you lightly press the multi-information meter switch, the display screen
switches in the following order.
1- Odometer (Type1)/Tripmeter
2- Odometer (Type1)/Tripmeter
3- Service
Odometer/Tripmeter
The operation method is the same as when the ignition switch or the operation
mode is OFF.
Refer to “Odometer/Tripmeter” for further details.
Service reminder
This displays the distance and number of months until the next periodic inspection.
Refer to “Service reminder”.
SEE MORE:
Air purifier
An air filter has been incorporated into this air conditioning so that dirt and
dust are cleaned from the air.
Replace the air filter periodically as its ability to clean the air will be reduced
as it collects pollen and dirt. For the maintenance interval, refer to the “SERVICE
BOOKLET”.
Rear–centre three–point seat belt
The rear–centre three–point seat belt must be worn correctly as shown in the
illustration.
1. Pull the seat belt and fit tongue (A) into the black buckle (C). 2. Push
tongue (B) firmly into the red buckle (D).
When the rear–centre three–point seat belt is not being used, stow the
© 2010-2025 Copyright www.mioutlander.com
