Mitsubishi Outlander: ASC operation display or ASC OFF display
- ASC operation display/ASC indicator
The display/indicator will blink
when the ASC is operating.
- ASC OFF display/ASC OFF indicator
This display/incicator will turn on
when the ASC is turned off with the
“ASC OFF” switch.
Note
► The combination of items shown on the display varies depending on the vehicle model.
Caution
► When 
display/indicator blinks,
ASC is operating, which means that the road is slippery or that your vehicle’s wheels
are beginning to slip. If this happens, drive slower with less accelerator input.
► If the temperature in the braking system continues to increase due to continuous
brake control on a slippery road surface, the
display/indicator will blink. To prevent
the brake system from overheating, the brake control of the traction control function
will be temporarily suspended.
The engine control of the traction control function and normal brake operation will
not be affected. Park your vehicle in a safe place. When the temperature in the
braking system has come down, the display/indicator
will be turned off and the traction control function will start operating again.
Note
► The display/indicator may
turn on when you start the engine. This means that the battery voltage momentarily
dropped when the engine was started. It does not indicate a malfunction, provided
that the display goes out immediately.
► When a compact spare tyre has been put on your vehicle, the gripping ability of
the tyre will be lower, making it more likely that the
display/indicator will blink.
READ NEXT:
ASC warning display
If an abnormal condition occurs in the system, the following display/indicator
will turn on.
- ASC indicator
- ASC OFF display/ASC OFF indicator
Note
► The combination of items shown on
Towing
Caution
► When towing the vehicle with only the front wheels or only the rear wheels
raised off the ground, do not place the ignition switch in the “ON” position. Placing
the ignition
Cruise control
Cruise control is an automatic speed control system that keeps a set speed. It
can be activated at speeds from about 40 km/h (25 mph) up to about 200 km/h (124
mph).
Caution
► When you do
SEE MORE:
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
► On vehicles with the Auto Stop & Go (AS&G) system, the starter will not operate
unless
If your vehicle is stuck: in sand, mud or snow
If the vehicle becomes stuck in snow, sand, or mud, it can often be moved by
a rocking motion. Move the gearshift lever or selector lever alternately between
the 1st and Reverse position (with manual transmission), the “L” (LOW) and “R” (REVERSE)
position (with INVECS–II 4A/T), and t
