Mitsubishi Outlander manuals

Mitsubishi Outlander: Towing

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Active stability control (ASC) / Towing

► When towing the vehicle with only the front wheels or only the rear wheels Caution

► When towing the vehicle with only the front wheels or only the rear wheels raised off the ground, do not place the ignition switch in the “ON” position. Placing the ignition switch in the “ON” position could cause the ASC to operate, resulting in an accident.
Note that the correct towing method depends on the transmission type and the vehicle’s drive configuration. For details, refer to “Towing”.

READ NEXT:

 Cruise control

Cruise control is an automatic speed control system that keeps a set speed. It can be activated at speeds from about 40 km/h (25 mph) up to about 200 km/h (124 mph). Caution ► When you do

 Cruise control switches

A- “ON OFF” switch Used to turn on and off the cruise control. B- “COAST SET” switch Used to reduce the set speed and to set the desired speed. C- “ACC RES” switch Used to increase

 To activate

1. With the ignition switch in the “ON” position, press the “ON OFF” switch (A) to turn on the cruise control. The “CRUISE” indication lamp in the meter cluster will come on. Not

SEE MORE:

 Deployment of side airbags and curtain airbags

The side airbags and curtain airbags ARE DESIGNED TO DEPLOY when… The side airbags and curtain airbags are designed to deploy when the vehicle suffers a moderate-tosevere side impact to the middle of the passenger compartment. The typical condition is shown in the illustration. The seat bel

 Starting

Tips for starting ► Do not operate the starter motor continuously longer than 10 seconds; doing so could run down the battery. If the engine does not start, turn the ignition switch back to “LOCK”, wait a few seconds, and then try again. Trying repeatedly with the starter motor still

© 2010-2026 Copyright www.mioutlander.com