Mitsubishi Outlander manuals

Mitsubishi Outlander: To activate

1. With the ignition switch in the “ON” position, press the “ON OFF” switch (A) to turn on the cruise control. The “CRUISE” indication lamp in the meter cluster will come on.

Note

► If the cruise control is on when the ignition switch is turned to the “LOCK” Note

► If the cruise control is on when the ignition switch is turned to the “LOCK” or “ACC” position, cruise control will be on automatically the next time you start the engine. The “CRUISE” indication lamp will also be on.
► If the battery voltage is insufficient, the memory data for the cruise control may be erased.
As a result, the “CRUISE” indication lamp may not come on when you restart the engine.
If this happens, press the “ON OFF” switch once again to turn on the cruise control.

2. Confirm that the Twin Clutch SST control mode is set to “NORMAL” (on vehicles equipped with Twin Clutch SST). Refer to “Twin Clutch SST control mode”.

► The cruising speed cannot be set when the Twin Clutch SST control mode is set Note

► The cruising speed cannot be set when the Twin Clutch SST control mode is set to “SPORT” mode.

3. Accelerate or decelerate to your desired speed, then press and release the “COAST SET” switch (B) when the “CRUISE” indication lamp is illuminated. The vehicle will then maintain the desired speed.

Note

► When you release the “COAST SET” switch, the vehicle speed will be set. Note

► When you release the “COAST SET” switch, the vehicle speed will be set.

READ NEXT:

 To increase the set speed

There are 2 ways to increase the set speed. “ACC RES” switch Press and hold the “ACC RES” switch (C) while driving at the set speed, and your speed will then gradually increase. When you

 To decrease the set speed

There are 2 ways to decrease the set speed. “COAST SET” switch Press and hold the “COAST SET” switch (B) while driving at the set speed, and your speed will slow down gradually. When you

 To temporarily increase or decrease the speed

To temporarily increase the speed Depress the accelerator pedal as you would normally. When you release the pedal, you will return to your set speed. Note ► In some driving conditions, th

SEE MORE:

 Safety mechanism

If a hand or head is trapped in the closing sunroof, it will reopen automatically. Nonetheless, make sure that nobody puts their head or hand out of the sunroof when opening or closing. The opened sunroof will become operational after a few seconds. If the safety mechanism should be activated 5

 Instruments and controls

LHD 1. Combination headlamps and dipper switch Turn-signal lever Front fog lamp switch* Rear fog lamp switch Headlamp washer switch* 2. Instruments 3. Shift paddles* 4. Windscreen wiper and washer switch Rear window wiper and washer switch 5. Engine switch* 6. Cruise contr

© 2010-2026 Copyright www.mioutlander.com