Mitsubishi Outlander: Cruise control switches
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Starting and driving / Cruise control / Cruise control switches
A- “ON OFF” switch
Used to turn on and off the cruise control.
B- “COAST SET” switch
Used to reduce the set speed and to set the desired speed.
C- “ACC RES” switch
Used to increase the set speed and to return to the original set speed.
D- “CANCEL” switch
Used to deactivate the set speed driving.
Note
► When operating the cruise control switches, press the cruise control switches
correctly.
The set speed driving may be deactivated automatically if two or more switches of
the cruise control are pressed at the same time.
READ NEXT:
To activate
1. With the ignition switch in the “ON” position, press the “ON OFF” switch (A)
to turn on the cruise control. The “CRUISE” indication lamp in the meter cluster
will come on.
Not
To increase the set speed
There are 2 ways to increase the set speed.
“ACC RES” switch
Press and hold the “ACC RES” switch (C) while driving at the set speed, and your
speed will then gradually increase.
When you
To decrease the set speed
There are 2 ways to decrease the set speed.
“COAST SET” switch
Press and hold the “COAST SET” switch (B) while driving at the set speed, and
your speed will slow down gradually.
When you
SEE MORE:
Vehicles with sunroof
Room lamp
1 (OFF) - The lamp goes out. 2 ()
- The lamp illuminates when a door or the tailgate is opened and goes out when it
is closed. 3 (ON) - The lamp illuminates.
Spot lamps
4 - The lamp goes out. 5 - The lamp illuminates.
NOTE
If you leave the lamps on without running the engine,
Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
• Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and the
tailgate are closed, after which the system preparation mode will on
© 2010-2025 Copyright www.mioutlander.com
