Mitsubishi Outlander: AWC control fluid
To check the fluid level
The AWC control fluid reservoir is in the luggage compartment.
Note
► Check the fluid level in the reservoir 90 minutes or more after turning the ignition switch to the “LOCK” position.
1. Remove the lid of the cargo floor box (A) on the right side.
2. Remove the cover (B) while pressing the top of the cover (B) and the hook (C).
3. Check to make certain that the AWC control fluid level is always between the “MAX” and “MIN” level markings on the fluid reservoir and top up the fluid, if necessary.
Note
► Do not spill the fluid onto the luggage compartment.
If fluid is spilled, wipe it up immediately.
4. To install the cover, perform the removal steps in reverse.
Fluid type
READ NEXT:
Washer fluid
The windscreen washer fluid reservoir is in the engine compartment.
Check the washer fluid level at regular intervals and add washer fluid to reservoir
if necessary.
Open the reservoir cap and che
Brake fluid/Clutch fluid
The brake fluid and the clutch fluid share the reservoir tank.
To check the fluid level
The fluid level must be between the “MAX” and “MIN” marks on the reservoir.
The fluid level is monitored by a float. When the brake fluid level falls below
the “MIN” mark, the brake f
SEE MORE:
Roof carrier precaution
Caution
► Make sure that the weight of the luggage does not exceed the allowable roof
load.
If the allowable roof load is exceeded, this may cause damage to the vehicle.
The roof load is the total allowable load on the roof (the weight of the roof carrier
plus the weight of luggage pla
Modification/alterations to the electrical or fuel systems
MITSUBISHI MOTORS CORPORATION has always manufactured safe, high quality vehicles.
In order to maintain this safety and quality, it is important that any accessory
that is to be fitted, or any modifications carried out which involve the electrical
or fuel systems, should be carried out in acco
© 2010-2026 Copyright www.mioutlander.com
