Mitsubishi Outlander: Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Except for vehicles equipped with the keyless operation system, remove the key from the ignition switch. For vehicles equipped with the keyless operation system, put the operation mode in OFF.
2. Place the lamp switch in the “OFF” position, and leave the driver’s door open.
3. Pull the windscreen wiper and washer switch towards you and hold it there. (Since the ignition switch is in the “LOCK” position or the operation mode is in OFF, washer fluid will not be sprayed.)
4. After approximately 10 seconds, the buzzer will make a sound. Keep the windscreen wiper and washer switch pulled towards you. (If the windscreen wiper and washer switch was released, the setting change mode would be cancelled. To start over, perform the procedure again from step 3.)
5. When the buzzer stops, with the windscreen wiper and washer switch still pulled towards you, press the UNLOCK switch (A) on the remote control switch to select the security alarm settings mode.
The settings mode can be toggled by pressing the UNLOCK switch. The mode can be confirmed from the number of times the buzzer sounds.
6. Any of the following operations can be used to terminate the system settings change mode.
• Releasing the windscreen wiper and washer switch.
• Closing the driver’s door.
• Inserting the key into the ignition switch (except for vehicles equipped with
the keyless operation system).
• Putting the operation mode in ON or ACC. (vehicles equipped with the keyless
operation system)
• Placing the lamp switch in any position other than “OFF”.
• Allowing 30 seconds to pass without making any changes to the settings.
NOTE
• If anything with regard to making changes to the security alarm system settings is hard to understand, please consult your MITSUBISHI MOTORS Authorized Service Point.
• Avoid leaving valuable items inside the vehicle even when the security alarm system has been set to the “active” mode.
READ NEXT:
Setting the system
Follow the procedure below to set the system to the system armed mode.
1. Except for vehicles equipped with the keyless operation system, remove the
key from the ignition switch. For vehicles equip
Cancelling the system
The following methods can be used to cancel the system when it is in the system
preparation mode or the system armed mode.
• Pressing the UNLOCK switch on the remote control switch.
• Turning
Alarm activation
When the system is in the system armed mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the doors, tailgate or bonnet is opened
using a method other than the ke
SEE MORE:
Headlamps
Unhook the spring which secures the bulb, and then remove the bulb.
CAUTION
Never hold the halogen lamp bulb with a bare hand, dirty glove, etc. The
oil from your hand could cause the bulb to break the next time the headlamps or
position lamps are operated.
If the glass surface is dirty,
Rear shelf panel
Caution
► Do not place luggage or other items on the rear shelf panel. Any items on
the rear shelf panel would obstruct your rearward view, and they could fly forward
and cause injuries or other mishap in the event of hard braking.
To install
1. Insert the concave portion (A) on the un
