Mitsubishi Outlander: Cancelling the system

The following methods can be used to cancel the system when it is in the system preparation mode or the system armed mode.

• Pressing the UNLOCK switch on the remote control switch.
• Turning the ignition switch to the “ON” position (except for vehicles equipped with the keyless operation system).
• Putting the operation mode in ON (vehicles equipped with the keyless operation system).
• Opening any one of the doors or the tailgate, or inserting the key into the ignition switch (except for vehicles equipped with the keyless operation system) when the system is in the system preparation mode.
• Holding the keyless operation key and pressing the driver’s or front passenger’s door lock/ unlock switch, or the tailgate OPEN switch to unlock the doors and the tailgate (vehicles equipped with the keyless operation system).

NOTE

• If the bonnet is opened during the system preparation mode, the system preparation condition is suspended.

The system returns to the system preparation mode when the bonnet is closed.

• If the battery terminals are disconnected while the system is in the system preparation mode, the memory will be erased.

• It is possible to register up to 8 remote control switches for the keyless entry system and 4 remote control switches for the keyless operation system.

As long as they are registered, any of the remote control switches, other than the one used to activate the system, can be used to cancel the system.

If you want to register additional remote control switches, please contact a MITSUBISHI MOTORS Authorized Service Point.

• The activation distance for the keyless entry system is approximately 4 m.

If it is not possible to lock or unlock the vehicle by pressing the switch at the correct distance or the security alarm system cannot be set or cancelled using the switch, the battery may need to be replaced.

Replace the battery at a MITSUBISHI MOTORS Authorized Service Point.

• If the UNLOCK switch on the remote control switch, or the driver’s or front passenger’s door lock/unlock switch is pressed and no door or the tailgate is opened within 30 seconds, the doors and the tailgate will automatically relock. In this case as well, the system preparation mode will go into effect.

• The time between pressing the UNLOCK switch on the remote control switch, or the driver’s or front passenger’s door lock/unlock switch and automatic locking can be adjusted.

Consult a MITSUBISHI MOTORS Authorized Service Point.

On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.

Refer to the separate owner’s manual for details.

READ NEXT: