Mitsubishi Outlander: “ASC OFF” switch
The ASC is automatically activated when the ignition switch is turned to the “ON” position. You can deactivate the system by pressing down the “ASC OFF” switch for 3 seconds or longer.
When the ASC is deactivated, the display/indicator will turn on. To reactivate the ASC, momentarily press the “ASC OFF” switch; the display/indicator is turned off.
Caution
► For safety reasons, the “ASC OFF” switch should be operated when your vehicle
is stopped.
► Be sure to keep the ASC on while driving in normal circumstances.
Note
► When moving out of mud, sand or fresh snow, pressing the accelerator pedal
may not allow the engine speed to increase. In such situations, temporarily turning
off the ASC with the “ASC OFF” switch will make it easier to move out your vehicle.
► Using the “ASC OFF” switch turns off both the stability control function and the
traction control function.
► If you continue to press the “ASC OFF” switch after the ASC is turned off, the
“mistaken operation protection function” will activate and the ASC will turn back
on.
READ NEXT:
ASC operation display or ASC OFF display
- ASC operation display/ASC indicator
The display/indicator will blink
when the ASC is operating.
- ASC OFF display/ASC OFF indicator
This display/incicator will turn on
when the ASC is turned o
ASC warning display
If an abnormal condition occurs in the system, the following display/indicator
will turn on.
- ASC indicator
- ASC OFF display/ASC OFF indicator
Note
► The combination of items shown on
Towing
Caution
► When towing the vehicle with only the front wheels or only the rear wheels
raised off the ground, do not place the ignition switch in the “ON” position. Placing
the ignition
SEE MORE:
Safety-Optimized RISE Body Structure
The reassuringly solid feeling one gets driving the new Lancer is rooted in a
body structure engineered with greater inherent strength than its predecessor.
That is one reason the new platform can be used for a variety of model types,
including the new-generation Outlander SUV. Of course, the
Headlamp washer switch
The headlamp washer can be operated when the ignition switch is in the “ON” or
“ACC” position and the headlamps are on.
Push the button once and the washer fluid will be sprayed on to the headlamps.
Note
► If the ignition switch is in the “ON” or “ACC” position and the
