Mitsubishi Outlander: Changing the time until “REST REMINDER” is displayed
The time until the display appears can be changed.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select “ALARM” (rest time setting).
3. Press and hold the multi-information meter switch for about 2 seconds or more to display “ALARM” (rest time setting).
4. Lightly press the multi-information meter switch to select the time until
the display.
5. Press and hold the multi-information meter switch for about 2 seconds or more,
the setting is changed to the selected time.
Note
► If the battery is disconnected, the unit setting is erased from memory and
is automatically set to OFF.
► The drive time is reset when the ignition switch is turned off.
READ NEXT:
Changing the turn-signal sound
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to
Changing the momentary fuel consumption display (Type 2)
It is possible to change the bar graph setting of the momentary fuel consumption
display.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setti
Returning to the factory settings
All of the function settings can be returned to their factory settings.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to th
SEE MORE:
Rear room lamp
The room lamp can be turned on by sliding the room lamp switch.
1 (ON) - The room lamp goes on.
2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds after the door or rear hatch is closed.
However, the lamp goes off immediately in the following ca
SRS servicing
WARNING
• We recommend any maintenance performed on or near the components of the
SRS to be performed by a MITSUBISHI MOTORS Authorized Service Point.
Improper work on the SRS components or wiring could result in inadvertent deployment
of the airbags, or could render the SRS inoperative; ei
