Mitsubishi Outlander: Filling the fuel tank
Warning
► When handling fuel, comply with the safety regulations displayed by garages
and filling stations.
► Before removing the fuel cap, be sure to get rid of your body’s static electricity
by touching a metal part of the car or the fuel pump. Any static electricity on
your body could create a spark that ignites fuel vapour.
► Perform the whole refueling process (opening the fuel tank filler door, removing
the fuel cap, etc.) by yourself. Do not let any other person come near the fuel
tank filler. If you allowed a person to help you and that person was carrying static
electricity, fuel vapour could be ignited.
► Do not move away from the fuel tank filler until refueling is finished. If
you moved away and did something else (for example, cleaning your windscreen) partway
through the refueling process, you could pick up a fresh charge of static electricity.
► If the tank cap must be replaced, use only a MITSUBISHI MOTORS original part.
Fuel tank capacity
2WD: 59 litres
4WD: 55 litres
Refueling
1. Before filling with fuel, stop the engine.
2. The fuel tank filler is located on the rear left side of your vehicle.
Open the fuel tank filler door by pulling the release lever located on the side of the driver’s seat.
3. Open the fuel tank filler tube by slowly turning the cap anticlockwise.
A- Remove
B- Close
Caution
► Since the fuel system may be under pressure, remove the fuel tank filler tube cap slowly. This relieves any pressure or vacuum that might have built up in the fuel tank. If you hear a hissing sound, wait until it stops before removing the cap. Otherwise, fuel may spray out, injuring you or others.
4. While filling with fuel, store the cap in the capholder located on the inside of the fuel tank filler door.
5. Insert the gun in the tank port as far as it goes.
Caution
► Do not tilt the gun.
6. When the gun stops automatically, do not fill with fuel any more.
7. To close, turn the fuel tank filler tube cap slowly clockwise until you hear
clicking sounds, then gently push the fuel tank filler door closed.
READ NEXT:
Installation of accessories
We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
► The installation of accessories, optional parts, should only be carried out
within the limits prescribed by law in
Modification/alterations to the electrical or fuel systems
MITSUBISHI MOTORS CORPORATION has always manufactured safe, high quality vehicles.
In order to maintain this safety and quality, it is important that any accessory
that is to be fitted, or any mod
Genuine parts
MITSUBISHI MOTORS has gone to great lengths to bring you a superbly crafted automobile
offering the highest quality and dependability.
Use MITSUBISHI MOTORS Genuine Parts, designed and manufactured
SEE MORE:
Average speed display
This displays the average speed from the last reset to the present time.
There are the following 2 mode settings.
For the method for changing the average speed display setting, refer to “Changing
the function settings (when the ignition switch or the operation mode is ON)”.
Manual reset m
Wiper and washer switch
Windscreen wipers
The windscreen wipers can be operated with the ignition switch in the “ON” or
“ACC” position.
If the blades are frozen to the windscreen or rear window, do not operate the
wipers until the ice has melted and the blades are freed, otherwise the wiper motor
may be dam
