Mitsubishi Outlander: Fuel remaining display screen
This displays the amount of fuel remaining.
CAUTION
• For petrol-powered vehicles, do not run out of fuel, or the catalytic converter may be adversely affected.
If the warning display appears, refuel as soon as possible.
• For diesel-powered vehicles, do not drive with an extremely low fuel level; running out of fuel could cause damage to the fuel system.
NOTE
• It may take several seconds to stabilise the display after refilling the tank.
• If fuel is added with the ignition switch or the operation mode is in ON, the fuel gauge may incorrectly indicate the fuel level.
Fuel lid mark
The arrow (A) indicates that the fuel tank filler is located on the left side of the body.
Fuel remaining warning display
When the fuel is reduced to about 10 litres, the information screen switches
to the interrupt display of the fuel remaining warning display, and the
mark (B) on the fuel remaining display
flashes slowly (about once per second). After a few seconds, the information screen
returns from the fuel remaining warning display to the previous screen.
When the fuel is reduced further to about 5 litres, the information screen switches
to the fuel remaining warning display and the
mark (B) on the fuel remaining display
flashes quickly (about twice per second).
NOTE
• On inclines or curves, the display may be incorrect due to the movement of fuel in the tank.
READ NEXT:
Service reminder
Displays the approximate time until the next periodic inspection recommended
by MITSUBISHI MOTORS. “---” is displayed when the inspection time has arrived.
NOTE
• Depending on the vehicle s
Door ajar warning display screen (when the ignition switch or the operation
mode
is ON)
If any of the doors or the tailgate is not completely closed, this displays the
open door or tailgate.
If the vehicle speed exceeds approximately 8 km/h (5 mph) while a door is ajar,
a buzzer s
Changing the function settings (when the ignition switch or the operation
mode
is ON)
1. Stop the vehicle in a safe place.
Firmly apply the parking brake and put the gearshift lever into the “N” (Neutral)
position (M/T) or the selector lever into the “P” (PARK) position (CVT
SEE MORE:
Reversing sensor system
This system operates when you are backing the vehicle.
It uses corner and back sensors to detect an obstacle and the information screen
in the multi-information display and the buzzer to inform you of the approximate
distance to the obstacle.
Caution
► The reversing sensor system assis
Automatic headlamp levelling (vehicles with discharge headlamps)
This mechanism automatically adjusts the direction of the headlamps (beam position)
depending on changes in the condition of the vehicle, such as the number of occupants
or luggage weight. When the headlamps are illuminated with the ignition switch or
the operation mode in ON, the beam positio
