Mitsubishi Outlander: Headlamp flasher
Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Instruments and controls / Combination headlamps and dipper switch / Headlamp flasher
The high-beams flash when the lever is pulled slightly (2), and will go off when it is released.
When the high-beam is on, the high-beam indication lamp in the instrument cluster will illuminate.
NOTE
• The high-beams can also flash when the lamp switch is OFF.
• If you turn the lamps off with the headlamps set to high-beam, the headlamps
are automatically returned to their low-beam setting when the lamp switch is next
turned to the 
position.
READ NEXT:
Welcome light
This function turns on the position and tail lamps for about 30 seconds after
the UNLOCK switch (A) on the remote control transmitter is pressed when the combination
headlamps and dipper switch is
Coming home light
This function turns on the headlamps in the low beam setting for about 30 seconds
after the ignition switch is turned to the “OFF” position or the operation mode
is put in OFF.
1. Turn the co
SEE MORE:
On a snow-covered or frozen
► When driving on a snow-covered or frozen road, it is recommended that you use
snow tyres or tyre chains. Refer to the “Snow tyres” and “Tyre chains” sections.
► Avoid high-speed operation, sudden acceleration, abrupt brake application and
sharp cornering.
► Depressi
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position,
and goes off after a few seconds.
Always make sure that the lamp goes off before driving.
With the ignition switch in the “ON” position, the brake warning lamp illuminates
under the following conditions: &
© 2010-2025 Copyright www.mioutlander.com
