Mitsubishi Outlander: Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle.
: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
: Front of the vehicle
4. While pressing the tab (D), pull out the bulb (E).
5. To install the bulb, perform the removal steps in reverse.
Caution
► Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is highly pressurized, so dropping, knocking,
or scratching a halogen lamp bulb can cause it to shatter.
► Never hold the halogen lamp bulb with a bare hand, dirty glove, etc. The oil from
your hand could cause the bulb to break the next time the headlamps are operated.
If the glass surface is dirty, it must be cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
READ NEXT:
Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)
Do not attempt to disassemble or repair headlamps, and do not attempt to replace
their bulbs.
Warning
► A high voltage is present in the power circuit and in the bulbs and bulb
terminals.
Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2
Position lamps (except for vehicles equipped with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the v
SEE MORE:
Interior
The Outlander Sport's interior is simple but not plain. There are enough
chrome- and metal-looking accents to keep the interior from being boring.
The climate controls are in the form of easy-to-decipher knobs, and the
stereo system is straightforward, which I appreciated even though it looks
Tips for starting
(1) Do not operate the starter motor continuously for anything longer than 10
seconds; doing so could run down the battery. If the engine does not start, turn
the ignition switch back to “LOCK”, wait a few seconds, and then try again. Trying
repeatedly with the starter motor still turning
