Mitsubishi Outlander: How to enter PTYs in the memory
Mitsubishi Carisma / Mitsubishi Carisma Owner's Manual / For pleasant driving / UKW/MW/LW electronic tuning radio with tape player* / How to enter PTYs in the memory
As many as 6 PTYs can be entered in the memory.
Follow the steps described below.
1. Press either the TUNE/SEEK button (5 or 6) to tune the PTY to be entered in
the memory.
2. Press one of the memory select buttons (7) for about 2 seconds
or longer. The sound will be momentarily interrupted while the PTY is being entered
into the memory. The number of the button corresponding to the entry into the memory,
and the PTY are displayed.
3. The preset memory setting is retrieved by pressing
the button and then releasing it within about 2 seconds.
NOTE
Disconnecting the battery terminal erases all PTYs stored in the memory.
READ NEXT:
To change the language of PTY display
You can select your favourite language between English, French, German, Swedish,
Spanish and Italian.
1. Turn off the radio. 2. Turn the radio back on while holding down the PTY
button (B). 3. An
To listen to a tape
1- Cassette slot 2- TAPE button 3- Cassette eject button 4/5- PROG (Program
selector, Fast-forward/Fast-rewind) buttons 6- MTL (Tape selector) button 7-
(Dolby noise reduction) button 8-
Tape
How to fast forward/rewind the tape
Fast forward
Press the PROG button (4 or 5) that is in the same direction as shown by the
display (8) to fast forward.
Fast rewind
Press the PROG button (4 or 5) that is in the opposite directi
SEE MORE:
Confident Braking Performance
The all-new 2008 Lancer GTS not only tames curves, but does so with the
confident stopping power of the same brakes as the larger, heavier Outlander SUV
-- 11.6-in. (294 mm) vented discs in front and 11.9-in. (302 mm) solid discs in
rear. The Lancer DE and ES models employ 10.9-in. (276 mm) ve
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position,
and goes off after a few seconds.
Always make sure that the lamp goes off before driving.
With the ignition switch in the “ON” position, the brake warning lamp illuminates
under the following conditions: &
© 2010-2025 Copyright www.mioutlander.com
