Mitsubishi Outlander: UKW/MW/LW electronic tuning radio with tape player*
The audio system can be used when the ignition switch is in the “ON” or “ACC” position.
A– Display window
B– Audio system
NOTE
(1) The MITSUBISHI Genuine CD player or CD autochanger can be connected to
this audio system. The CD player or the CD autochanger can be operated by the switch
on the audio body. Refer to “Connection of a CD player or a CD autochanger” on page
6–13.
(2) To listen to the audio system while the engine is stopped, turn the
ignition key to the “ACC” position.
(3) When a cellular phone is used inside the
vehicle, noise may be produced from the audio equipment. This does not mean that
something is wrong with the audio equipment. In such a case, use the cellular phone
at a place as far as possible from the audio equipment.
(4) In the case of misuse
(entry of a foreign object or water, smoke or odor, etc.), immediately stop the
operation and have the audio system checked at an authorized MITSUBISHI dealer.
Never try to repair it by yourself. Avoid continuous usage without inspection by
a qualified person.
(5) The audio system’s control panel can be removed to deter
thieves. For details, refer to the section entitled “Audio system anti-theft feature”
on page 6–26.
- To listen to the radio
- How to adjust the volume
- How to adjust the tone
- How to adjust the tune
- How to enter frequencies in the memory
- Radio data system (RDS)
- How to enter PTYs in the memory
- To change the language of PTY display
- To listen to a tape
- How to fast forward/rewind the tape
- Connection of a CD player or a CD autochanger
READ NEXT:
To listen to the radio
1- PWR (On-off) switch 2- VOL (Volume control) knob 3- U/M/L (UKW/MW/LW selection)
button 4- Audio adjust button 5- AUDIO button 6- TUNE/SEEK (Down-step/Down-seek)
button 7- TUNE/SEEK (Up-step/U
How to adjust the volume
VOL (Volume control)-2
Turn the knob clockwise to increase the volume
How to adjust the tone
Press the AUDIO button (5) to select BASS - TREBLE - FADER - BALANCE Audio adjust
mode off.
BASS (Bass tone control) Press the audio adjust button (4) either
or
to select the desired bass tone
SEE MORE:
LW/MW/FM digital tuning radio with CDplayer
The audio system can only be used when the ignition switch is in the “ON” or
“ACC” position.
NOTE:
● When listening to the audio system with the engine stopped, be sure to turn
the ignition switch to the “ACC” position.
● If a cellular phone is used inside the vehicle,
Ventilators
1- Centre ventilators 2- Side ventilators
Air flow and direction adjustments
3- Ventilator dial 4- Knob
– Open
– Close
Set the ventilator dial (3) to the open position. Air always flows out from the
ventilator when the blower is switched on.
Adjust the direction of the air flow b
