Mitsubishi Outlander: To listen to the radio

1- PWR (On-off) switch
2- VOL (Volume control) knob
3- U/M/L (UKW/MW/LW selection)
button
4- Audio adjust button
5- AUDIO button
6- TUNE/SEEK (Down-step/Down-seek)
button
7- TUNE/SEEK (Up-step/Up-seek) button
8- Memory select buttons
9- Frequency
display window
10- Preset memory number display
11- ST (Stereo) indicator
1. Press the PWR switch (1) to turn on the radio.
Press the PWR switch again
to switch it off.
2. Press the U/M/L button (3) to select the desired band (U1/U2/MW/LW).
3. Press the TUNE/SEEK button (6 or 7) or one of the memory select buttons (8) to
tune to a station.
Refer to “How to adjust the tune” or “How to enter frequencies
in the memory” on page 6–5.
READ NEXT:
VOL (Volume control)-2
Turn the knob clockwise to increase the volume
Press the AUDIO button (5) to select BASS - TREBLE - FADER - BALANCE Audio adjust
mode off.
BASS (Bass tone control) Press the audio adjust button (4) either
or
to select the desired bass tone
Manual tuning
The frequency changes every time the TUNE/SEEK button (6 or 7) is pressed. Press
the button to select the desired station.
Automatic tuning
After keeping the TUNE/SEEK button (6 or
SEE MORE:
1- Location of the tread wear indicator
2- Tread wear indicator
Check the tyres for cuts, cracks and other damage.
Replace the tyres if there are deep cuts or cracks.
Also check each tyre for pieces of metal or pebbles.
The use of worn tyres can be very dangerous because of the greater chance
1. Press the PWR button (3) to turn on the audio system. The system turns on
in the last mode used.
2. Connect your USB memory device to the USB input terminal. Refer to “How to
connect a USB memory device”.
3. Press the CD button (2) several times to switch to the USB mode. The input
mo
© 2010-2025 Copyright www.mioutlander.com
