Mitsubishi Outlander: Service reminder
Displays the approximate time until the next periodic inspection that MITSUBISHI MOTORS recommends.
“---” is displayed when the inspection time has arrived.
Note
► Depending on the vehicle specifications, the displayed time until the next
periodic inspection may differ from that recommended by MITSUBISHI MOTORS.
In addition, the display settings for the next periodic inspection time can be modified.
To modify the display settings, have it adjusted at a MITSUBISHI MOTORS Authorized
Service Point.
For more details, consult a MITSUBISHI MOTORS Authorized Service Point.
1. Displays the time until the next periodic inspection.
Note
► The distance is shown in units of 100 km (100 miles). The time is shown in units of months.
2. This informs you that a periodic inspection is due. We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
At that time, when the ignition switch is switched from “OFF” to “ON”, the warning display is displayed for a few seconds on the information screen.
3. After your vehicle is inspected at a MITSUBISHI MOTORS Authorized Service Point, it displays the time until the next periodic inspection.
To reset
The “---” display can be reset while the ignition switch is “OFF”. When the display is reset, the time until the next periodic inspection is displayed and the warning display is no longer displayed when the ignition switch is switched from “OFF” to “ON”.
1. When you lightly press the multi-information meter switch a few times, the information screen switches to the service reminder display screen.
2. Press and hold the multi-information meter switch for about 2 seconds or more
to display 
and make it flash. (If there
is no operation for about 10 seconds with flashing, the display returns to the previous
screen.)
3. Lightly press the multi-information meter switch while the icon is flashing to change the display from “---” to “CLEAR”. After this, the time until the next periodic inspection will be displayed.
Caution
► The customer is responsible for making sure that periodic inspection and maintenance are performed. Inspections and maintenance must be performed to prevent accidents and malfunctions.
Note
► “---” display cannot be reset when the ignition switch is “ON”.
► When “---” is displayed, after a certain distance and a certain period of time,
the display is reset and the time until the next periodic inspection is displayed.
► If you accidentally reset the display, we recommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
READ NEXT:
Door ajar warning display screen (when the ignition switch is “ON”)
If any of the doors or the rear hatch is not completely closed, this displays
the open door or rear hatch.
If the vehicle speed exceeds approximately 8 km/h (5 mph) while a door is ajar,
a buzz
Changing the function settings (when the ignition switch is “ON”)
1. Stop the vehicle in a safe place.
Firmly apply the parking brake and put the gearshift lever into the “N” (Neutral)
position (M/T), the selector lever into the “P” (PARK) position (CVT)
Changing the reset mode for average fuel consumption and average speed
The mode conditions for the average fuel consumption and average speed display
can be switched between “Auto reset” and “Manual reset”.
1. Press and hold the multi-information meter switch
SEE MORE:
Seat adjustment
Adjust the driver’s seat so that you are comfortable and that you can reach the
pedals, steering wheel, switches etc. while retaining a clear field of vision.
WARNING
• Do not attempt to adjust the seat while driving. This can cause loss of
vehicle control and result in an accident. After
Auto Stop & Go (AS&G) system
The Auto Stop & Go (AS&G) system automatically stops and restarts the engine
without operating the ignition switch when the vehicle is stopped, such as at a
traffic light or in a traffic jam, to reduce exhaust gases, increase fuel efficiency.
Caution
► If the vehicle will be sto
