Mitsubishi Outlander: How to enter PTYs in the memory
As many as 6 PTYs can be entered in the memory.
Follow the steps described below.
1. Press either the TUNE/SEEK button (5 or 6) to tune the PTY to be entered in
the memory.
2. Press one of the memory select buttons (7) for about 2 seconds
or longer. The sound will be momentarily interrupted while the PTY is being entered
into the memory. The number of the button corresponding to the entry into the memory,
and the PTY are displayed.
3. The preset memory setting is retrieved by pressing
the button and then releasing it within about 2 seconds.
NOTE
Disconnecting the battery terminal erases all PTYs stored in the memory

READ NEXT:
You can select your favourite language between English, French, German, Swedish,
Spanish and Italian.
1. Turn off the radio. 2. Turn the radio back on while holding down the PTY
button (B). 3. An
The radio will automatically tune in to traffic information broadcasts while
receiving UKW broadcasts, playing cassettes.
To select this function, follow the instructions below.
1. Press the TP bu
The traffic information program standby function is turned on (with the TP indicator
(11) shown on the display) and after about 45 seconds since the RDS indicator (9)
turns off due to weak signal
SEE MORE:
Set the mode selection dial to the position shown in the illustration and set
the air selection switch (A) to the outside position.
Adjust the temperature by turning the temperature control dial clockwise or anticlockwise.
Select the desired blower speed.
NOTE
When the maximum heating is nee
To park the vehicle, first bring it to a complete stop, fully engage the parking
brake, and then move the gearshift lever to the “P” (PARK) position.
If you are going to leave the vehicle unattended, always switch off the engine
and carry the key.
Note
► On a slope, be sure to appl
© 2010-2025 Copyright www.mioutlander.com
