Mitsubishi Outlander manuals

Mitsubishi Outlander: To change the language of PTY display

You can select your favourite language between English, French, German, Swedish, Spanish and Italian.

1. Turn off the radio.
2. Turn the radio back on while holding down the PTY button (B).
3. An alarm will sound and the system will enter PTY Language Switching mode.
4. Use the H button (C) or the M button (D) to select the desired language. Press the SET button (E) to register your selection.
5. Press the button on the left (A) to cancel the selection. The system will revert to the settings prior to accessing PTY Language Switching mode.

Traffic information

READ NEXT:

 Traffic information

The radio will automatically tune in to traffic information broadcasts while receiving UKW broadcasts, playing cassettes. To select this function, follow the instructions below. 1. Press the TP bu

 TP (Traffic information Program) search function

The traffic information program standby function is turned on (with the TP indicator (11) shown on the display) and after about 45 seconds since the RDS indicator (9) turns off due to weak signal

 Emergency broadcasts

If an emergency broadcast is caught while receiving a UKW broadcast or playing back a cassette tape with the ignition switch in “ACC” or “ON” position, the display will show “ALARM” an

SEE MORE:

 Disposal information for used batteries

Your vehicle contains batteries and/or accumulators. Do not mix with general household waste. For proper treatment, recovery and recycling of used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2006/66/EC. By disp

 Sunroof

Sunroof The sunroof can only be operated with the ignition switch in the “ON” position. 1- Open. 2- Tilt up. 3- Close, Tilt down. To open, press the switch (1) To stop the moving sunroof, press the switch (2) or (3). NOTE: ● The sunroof automatically stops just before reaching th

© 2010-2026 Copyright www.mioutlander.com