Mitsubishi Outlander: Identification of fuse
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Fuses / Fuse load capacity / Identification of fuse
READ NEXT:
Fuse replacement
1. Before replacing a fuse, always turn off the electrical circuit concerned
and place the ignition switch in the “LOCK” position.
2. Remove the fuse puller (A) from the inside of the fuse box
Replacement of lamp bulbs
Before replacing a bulb, ensure the lamp is off. Do not touch the glass part
of the new bulb with your bare fingers; the skin oil left on the glass will evaporate
when the bulb gets hot and the va
Bulb capacity
When replacing a bulb, use a new bulb with the same wattage and colour.
Outside
Except for vehicles equipped with high intensity discharge headlamps
1. Front turn-signal lamps: 21 W (WY21W)
2. H
SEE MORE:
Cruise control
Cruise control is an automatic speed control system that keeps a set speed. It
can be activated at about 40 km/h (25 mph) or more.
CAUTION
• When you do not wish to drive at a set speed, turn off the cruise control
for safety.
• Do not use cruise control when driving conditions will not
Outside rear-view mirrors
To adjust the mirror position
The outside rear-view mirrors can be operated when the ignition switch or the
operation mode is in ON or ACC.
WARNING
• Do not attempt to adjust the rear-view mirrors while driving. This can be
dangerous.
Always adjust the mirrors before driving.
• Your ve
© 2010-2026 Copyright www.mioutlander.com
