Mitsubishi Outlander manuals

Mitsubishi Outlander: Bulb capacity

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Bulb capacity

When replacing a bulb, use a new bulb with the same wattage and colour.

Outside

Except for vehicles equipped with high intensity discharge headlamps

Except for vehicles equipped with high intensity discharge headlamps

1. Front turn-signal lamps: 21 W (WY21W)
2. Headlamps, high-beam: 60 W (HB3)
3. Headlamps, low beam: 51 W (HB4)
4. Front fog lamps1: 55 W (H11)
5. Position lamps: 5 W (W5W)
6. Side turn-signal lamps2: 5 W

Vehicles equipped with high intensity discharge headlamps

1. Front turn-signal lamps: 21 W (WY21W)
2. Bending lamps (Adaptive Front lighting System (AFS)): 55 W (H11)
3. Headlamps, high/low beam (Discharge bulb)2: 35 W
4. Front fog lamps1: 55 W (H11)
5. Position lamps: 5 W (W5W)
6. Side turn-signal lamps2: 5 W

1 If so equipped
2 Have the lamps bulbs replaced at a MITSUBISHI MOTORS Authorized Service Point.

► Check with a MITSUBISHI MOTORS Authorized Service Point when it is necessary Warning

► Check with a MITSUBISHI MOTORS Authorized Service Point when it is necessary to repair a high intensity discharge headlamp or to replace the bulb. The power circuit, bulb and electrodes generate high voltages that may cause a severe shock.

► For the side turn-signal lamp, it is not possible to repair or replace just Note

► For the side turn-signal lamp, it is not possible to repair or replace just the bulb.
Check with a MITSUBISHI MOTORS Authorized Service Point when the lamp needs to be repaired or replaced.

7. High-mounted stop lamp

7. High-mounted stop lamp
8. Rear fog lamp: 21 W (W21W)
9. Licence plate lamps: 5 W (W5W)
10. Reversing lamps: 16 W (W16W)
11. Stop and tail lamps: 21/5 W (W21/5W)
12. Rear turn-signal lamps: 21 W (WY21W)

Codes in parentheses indicate bulb types.

► The high-mounted stop lamp uses LEDs rather than bulbs. For repair and replacement, Note

► The high-mounted stop lamp uses LEDs rather than bulbs. For repair and replacement, we recommend you to consult a specialist.

Inside

1- Cargo room lamp: 8 W

1- Cargo room lamp: 8 W
2- Rear room lamp: 8 W
3- Front room & map lamps: 8 W

READ NEXT:

 Headlamps (low beam, except for vehicles with high intensity discharge headlamps)

1. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the left side, remove the bolt (A) holding down the relay box and move the relay box towards the rear of the v

 Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)

1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle. : Front of the vehicle 2

 Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)

Do not attempt to disassemble or repair headlamps, and do not attempt to replace their bulbs. Warning ► A high voltage is present in the power circuit and in the bulbs and bulb terminals.

SEE MORE:

 Windscreen washer

The washer fluid will be sprayed onto the windscreen by pulling the lever towards you. The wipers operate automatically several times while the washer fluid is being sprayed. CAUTION If the washer is used in cold weather, the washer fluid sprayed against the glass may freeze resulting in p

 Installing a child restraint system to the lower anchorage (ISOFIX child restraint mountings) and tether anchorage

Lower anchorage location Your vehicle’s rear seat is fitted with lower anchorages for attaching a child restraint system with ISOFIX mountings. Tether anchorage locations There are 2 child restraint anchorage points located on the back of the rear seatbacks. These are for fastening the ch

© 2010-2025 Copyright www.mioutlander.com