Mitsubishi Outlander: Headlamps (low beam, except for vehicles with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the left side, remove the bolt (A) holding down the relay box and move the relay box towards the rear of the vehicle.
: Front of the vehicle
2. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the right side, lift up the engine coolant reservoir (B).
: Front of the vehicle
3. When replacing the bulb on the right side of the vehicle in case of diesel-powered vehicles, turn the steering wheel to the left to create enough work space. And then, remove the clips (C) and screws (D) to turn up the cover (E).
4. Turn the bulb (F) anticlockwise, and then remove the headlamp bulb with holder.
: Front of the vehicle
5. While pressing the tab (G), pull out the bulb (H).
6. To install the bulb, perform the removal steps in reverse.
Caution
► Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is highly pressurized, so dropping, knocking,
or scratching a halogen lamp bulb can cause it to shatter.
► Never hold the halogen lamp bulb with a bare hand, dirty glove, etc. The oil from
your hand could cause the bulb to break the next time the headlamps are operated.
If the glass surface is dirty, it must be cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
READ NEXT:
Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2
Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)
Do not attempt to disassemble or repair headlamps, and do not attempt to replace
their bulbs.
Warning
► A high voltage is present in the power circuit and in the bulbs and bulb
terminals.
Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2
SEE MORE:
For cold and snow weather
Ventilation slots
The ventilation slots in front of the windscreen should be brushed clear after
heavy snowfall so that the operation of the heating and ventilation systems will
not be impaired.
Weatherstripping
To prevent freezing of the weatherstripping on the doors, bonnet, etc., they
sh
Emergency stop signal system
This is a device that reduces the possibility of rear end collisions by the rapid
and automatic blinking of the hazard warning lamps to alert vehicles approaching
from behind during sudden braking.
When the emergency stop signal system operates, the hazard warning indication
lamp in the instr
