Mitsubishi Outlander: Indication lamps
Turn-signal indication lamps/ Hazard warning indication lamps
These indication lamps blink in the following situations.
• When the turn-signal lever is moved to activate a turn-signal lamp.
• When the hazard warning flasher switch is pressed to activate the hazard warning
lamps.
• When the hazard warning lamps automatically activate due to sudden braking
while driving.
NOTE
• If these indication lamps blink too fast due to any operation other than sudden braking, the cause may be a blown lamp bulb or a faulty turn-signal connection.
High-beam indication lamp
This indication lamp illuminates when the high-beam is used.
Front fog lamp indication lamp
This lamp illuminates while the front fog lamps are on.
Rear fog lamp indication lamp
This lamp illuminates while the rear fog lamp is on.
Position lamp indication lamp
This indication lamp illuminates while the position lamps are on.
Diesel preheat indication lamp (diesel-powered vehicles)
This indicates the glow plug preheat condition.
[Except for vehicles equipped with keyless operation system] When the ignition switch is turned to the “ON” position, the lamp illuminates. As the glow plug becomes hot, the lamp goes out and the engine can be started.
[For vehicles equipped with keyless operation system] When the operation mode is put in ON, the lamp illuminates and preheating of the glow lamp starts automatically. As the glow plug becomes hot, the lamp goes out and the engine starts.
NOTE
• If the engine is cold, the diesel preheat indication lamp is on for a longer
time.
• When the engine is warm, the diesel preheat indication lamp does not come on
even if the ignition switch is turned to the “ON” position or the operation mode
is put in ON.
READ NEXT:
Warning lamps
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position
or the operation mode is put in ON, and goes off after a few seconds.
Always make sure that t
Information screen display
Brake warning display
This warning is displayed if you drive with the parking brake still applied.
The warning lamp in the instrument cluster only illuminates when the parking brake
is applied.
SEE MORE:
Multi-information meter switch
Each time the multi-information meter switch is operated, a sound is emitted
and the multi-information display changes between information such as warnings,
odometer, tripmeter, service reminder, engine coolant temperature (Type 1), average
and momentary fuel consumption, driving range, averag
Leg area heating
Set the mode selection dial to the position shown in the illustration and set
the air selection switch (A) to the outside position.
Adjust the temperature by turning the temperature control dial clockwise or anticlockwise.
Select the desired blower speed.
NOTE
When the maximum heating is nee
