Mitsubishi Outlander: Installation of accessories
Before fitting any accessories, please consult your authorized MITSUBISHI dealer.
(1) The installation of accessories, optional parts, etc., should only be carried
out within the limits prescribed by law in your country, and in accordance with
the guidelines and warnings contained within the documents accompanying this vehicle.
Only MITSUBISHI approved accessories should be fitted to your vehicle.
(2) Improper
installation of electrical parts could cause fire, please refer to the Modification/alterations
to the electrical or fuel systems section within this owner’s handbook.
(3) When
using a communication system such as a cellular phone or a radio set inside the
vehicle, a separate external antenna must be fitted. When a cellular phone or a
radio set is used by using an internal antenna alone, it may interfere with the
vehicle’s electrical system and adversely affect safe operation of the vehicle.
(4) Tyres and wheels which do not meet specifications must not be used. Refer to
the “Specifications” section for information regarding wheel and tyre sizes on page
10–11.
(5) Do not fail to read all relative instructions before first putting
into service and prior to the attachment or installation of accessories, parts or
other modifications to the vehicle!
Important points!
Due to the large number of accessory and replacement parts of different manufacturers in the market, it is not possible, not only for MITSUBISHI MOTOR SALES Europe B.V., but also an authorized MITSUBISHI dealer, to check whether the attachment or installation of such parts affects the driving safety of your MITSUBISHI-vehicle.
Even when such parts are officially authorized, for example by a “general operators permit” (an appraisal for the part) or through the execution of the part in an officially approved manner of construction, or when a single operation permit following the attachment or installation of such parts, it cannot be deduced from that alone, that the driving safety of your vehicle has not been affected. Consider also that there basically exists no liability on the part of the appraiser or the official. Only in the case of parts (MITSUBISHI original replacement or exchange parts as well as MITSUBISHI accessories) that are recommended and released by an authorized MITSUBISHI dealer and that are attached or installed by an authorized MITSUBISHI dealer can you assume, that optimal safety has been provided. The same also pertains to modifications of MITSUBISHI vehicles with respect to the production specifications. For your own safety, in such cases as well, you should only undertake modifications according to the recommendations of an authorized MITSUBISHI dealer.
READ NEXT:
Modification / alterations to the electric or fuel systems
MITSUBISHI has always manufactured safe, high quality vehicles. In order to maintain
this safety and quality, it is important that any accessory that is to be fitted,
or any modifications carried
Roof drip moulding
When installing the roof carrier, remove the roof drip moulding caps.
1. Open the cover (A) and remove the screws using a Philips screwdriver. 2.
Remove the caps by sliding them.
After removal o
Roof carrier precaution
CAUTION
(1) Make sure that the weight of the luggage does not exceed the allowable
roof load. If the allowable roof load is exceeded, this may cause damage to the
vehicle. The roof load is the to
SEE MORE:
Towing
If your vehicle needs to be towed
If you need to tow your vehicle, we recommend that you contact a MITSUBISHI MOTORS
Authorised Service Point or tow truck company.
In the following cases, transport the vehicle using a tow truck.
● The engine runs but the vehicle does not move, or an abn
Gas Mileage
The Lancer GT's gas mileage maxes out at an EPA-estimated 31 mpg on the
highway — a number that was merely average even back when this Lancer generation
was introduced. The smaller, more efficient 2.0-liter is rated 34 mpg on the
highway, which is still a ways off from the segment's 40 mpg b
