Mitsubishi Outlander manuals

Mitsubishi Outlander: General information

READ NEXT:

 Installation of accessories

Before fitting any accessories, please consult your authorized MITSUBISHI dealer. (1) The installation of accessories, optional parts, etc., should only be carried out within the limits prescribed

 Modification / alterations to the electric or fuel systems

MITSUBISHI has always manufactured safe, high quality vehicles. In order to maintain this safety and quality, it is important that any accessory that is to be fitted, or any modifications carried

 Roof drip moulding

When installing the roof carrier, remove the roof drip moulding caps. 1. Open the cover (A) and remove the screws using a Philips screwdriver. 2. Remove the caps by sliding them. After removal o

SEE MORE:

 Information screen (when the ignition switch or the operation mode is OFF)

Each time you lightly press the multi-information meter switch, the display screen switches in the following order. 1- Odometer (Type 1)/Tripmeter 2- Odometer (Type 1)/Tripmeter 3- Service reminder 4- Redisplay of a warning display screen

 Setting the system

1. Turn the ignition switch to the “LOCK” position. Also, if a key was used to start the engine, remove the key from the ignition switch. 2. Get out of the vehicle. Close all doors and rear hatch. 3. Press the LOCK switch (A) on the remote control switch, the driver’s or front passenger

© 2010-2025 Copyright www.mioutlander.com