Mitsubishi Outlander: Roof drip moulding
When installing the roof carrier, remove the roof drip moulding caps.
1. Open the cover (A) and remove the screws using a Philips screwdriver.
2.
Remove the caps by sliding them.
After removal of the roof carrier, replace the roof drip moulding caps.
READ NEXT:
Roof carrier precaution
CAUTION
(1) Make sure that the weight of the luggage does not exceed the allowable
roof load. If the allowable roof load is exceeded, this may cause damage to the
vehicle. The roof load is the to
Genuine parts
Don’t play around with substitutes.
MITSUBISHI has gone to great lengths to bring you a superbly crafted vehicle
offering the highest quality and dependability. Don’t reduce that quality and de
Used engine oils safety instructions
WARNING
(1) Prolonged and repeated contact may cause serious skin disorders, including
dermatitis and cancer. (2) Avoid contact with the skin as far as possible and
wash thoroughly after any cont
SEE MORE:
Suitability for various ISOFIX positions
Key of characters to be inserted in the table above:
• IUF- Suitable for ISOFIX forward child restraints systems of universal category
approved for use in the mass group.
• IL- Suitable for particular ISOFIX child restraint systems given in the following
list (MITSUBISHI genuine parts).
Redesigned Front Suspension
The MacPherson strut front suspension is similar in layout to the previous
Lancer's, but all-new, with a sharpened focus on enhancing rigidity while
reducing weight and lowering the roll center. Slightly longer suspension travel
(10 mm) enhances road holding even on rough roads, and road shock
© 2010-2026 Copyright www.mioutlander.com
