Mitsubishi Outlander: Genuine parts
Don’t play around with substitutes.
MITSUBISHI has gone to great lengths to bring you a superbly crafted vehicle offering the highest quality and dependability. Don’t reduce that quality and dependability by using substitute parts.
Always use MITSUBISHI Genuine Parts designed and manufactured to maintain your MITSUBISHI vehicle at top performance. The operation of vehicle components can be less efficient in case of using Non-Genuine Parts.
Failure to use Genuine Parts may invalidate any future warranty claim. MITSUBISHI will not be liable for any malfunction of your vehicle that may have been caused by the use of substitute parts in place of MITSUBISHI Genuine Parts.
At the MITSUBISHI dealer you can also get appropriate advice and the assembling of Genuine Parts will be handled professionally. MITSUBISHI Genuine Parts are identified by this mark and are available at all authorized MITSUBISHI dealers.
READ NEXT:
Used engine oils safety instructions
WARNING
(1) Prolonged and repeated contact may cause serious skin disorders, including
dermatitis and cancer. (2) Avoid contact with the skin as far as possible and
wash thoroughly after any cont
Protect the environment
It is illegal to pollute drains, water courses and soil. Use authorized waste
collection facilities, including civic amenity sites and garages providing facilities
for disposal of used oil and use
Driving and alcohol
Driving under the influence of alcohol is one of the most frequent causes of
accidents. Your driving ability can even be seriously impaired with blood alcohol
levels below the legal maximum. If yo
SEE MORE:
Headlamp levelling
Except for vehicles with discharge headlamps
The angle of the headlamp beam varies depending upon the load carried by the
vehicle.
The headlamp levelling switch can be used to adjust the headlamp illumination
distance (when the lower beam is illuminated) so that the headlamps’ glare does
Passenger compartment (LHD vehicles)
The fuse blocks in the passenger compartment are located behind the fuse lid
in front of the driver’s seat at the position shown in the illustration.
A- Main fuse block
B- Sub fuse block
1. Open the fuse lid and pull to remove it.
2. On vehicles with bottom cover, use the puller to loose
