Mitsubishi Outlander: Check engine warning lamp
This lamp is a part of an onboard diagnostic system which monitors the emissions, engine control system or CVT control system/Twin Clutch SST control system.
If a problem is detected in one of these systems, this lamp illuminates or flashes.
Although your vehicle will usually be drivable and not need towing, we recommend you to have the system checked as soon as possible.
This lamp will also illuminate when the ignition switch is turned “ON”, and goes off after the engine has started. If it does not go off after the engine has started, we recommend you to have the vehicle checked.
Caution
► Prolonged driving with this lamp on may cause further damage to the emission control system.
It could also affect fuel economy and drivability.
► If the lamp does not illuminate when the ignition switch is turned to the “ON”
position, we recommend you to have the system checked.
► If the lamp illuminates while the engine is running, avoid driving at high speeds
and we recommend you to have the system checked.
Accelerator pedal and brake pedal response may be negatively influenced under these
conditions.
Note
► The engine electronic control module accommodating the onboard diagnostic system
has various fault data (especially about the exhaust emission) stored.
This data will be erased if a battery cable is disconnected which will make a rapid
diagnosis difficult.
Do not disconnect a battery cable when the check engine warning lamp is ON.
READ NEXT:
Charge warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position,
and goes off after the engine has started.
A warning is also displayed on the multiinformation display.
Cautio
Fuel filter indicator display
When the ignition switch is “ON”, if more than specified limit water has accumulated
in the fuel filter, a warning display is displayed on the information screen in
the multi-information dis
SEE MORE:
Braking
All the parts of the brake system are critical to safety. We recommend you to
have the vehicle checked at regular intervals according to the service booklet.
CAUTION:
● Avoid driving habits that cause heavy braking and never “ride” the brakes by
resting your foot on the brake pedal w
To resume the set speed
If the set speed driving is deactivated by the condition described in “To deactivate”, you can resume the previously set speed by pressing the “ACC RES”
switch (C) while driving at a speed of about 40 km/h (25 mph) or higher.
Under either of the following conditions, however, using the
