Mitsubishi Outlander: Warning lamps
READ NEXT:
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position,
and goes off after a few seconds.
Always make sure that the lamp goes off before driving.
With the ignition swi
Check engine warning lamp
This lamp is a part of an onboard diagnostic system which monitors the emissions,
engine control system or CVT control system/Twin Clutch SST control system.
If a problem is detected in one of th
Charge warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position,
and goes off after the engine has started.
A warning is also displayed on the multiinformation display.
Cautio
SEE MORE:
Front room & map lamps
When replacing the bulb, put the front room & map lamps switch into the “OFF”
position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the lamp assembly. Gently pry to remove the lens.
2. While holding down the tab (A), pull out the bulb
Servicing of plastic parts
Use a sponge or chamois leather. If a car wax adheres on a grey or black rough
surface of the bumper, moulding or lamps, the surface becomes white. In such a case,
wipe it off using lukewarm water and soft cloth or chamois leather.
CAUTION
(1) Do not use a scrubbing brush or other hard tools a
© 2010-2025 Copyright www.mioutlander.com
