Mitsubishi Outlander: Interrupt display screen (when the ignition switch is “ON”)
Warning display
When there is information to be announced, such as a system fault, a sound is emitted and the information screen switches to the warning display screen.
Refer to the warning list and take the necessary measures.
Refer to “Warning display list (when the ignition switch is “ON”)”.
When the cause of the warning display is eliminated, the warning display goes out automatically.
To return to the screen displayed before the warning display
Even if the cause of the warning display is not eliminated, you can return to the screen that was displayed before the warning display.
If you press the multi-information meter switch, the display screen switches
to the screen that was displayed before the warning display and the
mark (A) is displayed.
Note
► Warning display screens with a 
or 
mark displayed in the upper right
of the screen can be switched. If you want to switch the display, press the multi-information
meter switch as follows.
: Press lightly.
: Press for about 2 seconds or more.
Redisplay of a warning display screen
When the mark is displayed, if you
lightly press the multi-information meter switch a few times, the warning display
screen you switched from is displayed again.
Other interrupt displays
The operation status of each system is displayed on the information screen.
Refer to the appropriate page in the warning display list for further details.
Refer to “Other interrupt displays (when the ignition switch is “ON”)”.
READ NEXT:
Selector lever position display screen (vehicles with CVT)/ Gearshift lever
position display screen (vehicles with Twin Clutch SST)
Shows the position of the selector lever or gearshift lever.
Refer to “Selector lever operation”.
Refer to “Gearshift lever position display”.
Outside temperature display screen
This shows the temperature outside the vehicle.
Note
► The display setting can be changed to the preferred units (°C or °F).
Refer to “Changing the function settings (when the ignition
Twin Clutch SST control mode display screen (vehicles equipped with Twin Clutch
SST)
The operation status of the Twin Clutch SST control mode is displayed.
Refer to “Twin Clutch SST control mode”.
SEE MORE:
Installing a child restraint system to the lower anchorage (ISOFIX child
restraint mountings)
and tether anchorage
Lower anchorage location
Your vehicle’s rear seat is fitted with lower anchorages for attaching a child
restraint system with ISOFIX mountings.
Tether anchorage locations
There are 2 child restraint anchorage points located on the back of the rear
seatbacks. These are for fastening the ch
Tyres and wheels
Since the driving torque can be applied to the 4 wheels, the driving performance
of the vehicle when operating in 4-wheel drive is greatly affected by the condition
of the tyres.
Pay close attention to the tyres.
► Install only the specified tyres on all wheels.
Refer to “Tyres and wh
