Mitsubishi Outlander: Odometer/Tripmeter
When the ignition switch is turned “ON”, the odometer display is given in the lower display window (1). The upper display window (2) shows the tripmeter A and tripmeter B distances in that sequence. It then shows the distance that was displayed before the ignition switch was last turned to the “OFF”.
Every time the reset button (3) is pressed lightly (less than one second), the upper display is changed as below.
Odometer
The odometer indicates the total distance the vehicle has travelled.
Tripmeter
There are two tripmeters: A and B. These indicate the distance travelled during a particular trip or period.
4– Tripmeter A indicates the distance travelled since the current trip begins.
5– Tripmeter B indicates the distance from an intermediate location.
To return the indication to 0, press the reset button for more than 1 second. Only the currently displayed value will be reset.
NOTE
(1) Display A and B each have a maximum distance of 999.9 mile (km).
(2)
When disconnecting the battery terminal for a long time, the memory of tripmeter
display A and B are cleared, and the display returns to “0”.
READ NEXT:
Tachometer
The tachometer indicates the engine speed (r/min). The tachometer can help you
obtain more economical driving and also warns you of excessive engine speeds.
CAUTION
During travel, watch the tach
Fuel gauge
The fuel gauge indicates the fuel level in the fuel tank irrespective of the
ignition switch position.
0- Empty 1- Full
CAUTION
Do not drive with an extremely low fuel level; running out of fue
Water temperature gauge
The water temperature gauge indicates the engine coolant temperature when the
ignition switch is “ON”.
CAUTION
If the indication needle enters the overheating zone while the engine is
runn
SEE MORE:
Cooling
Set the mode selection dial to the “”
position.
Set the air selection switch (A) to the outside position and push the air conditioning
switch (B).
Adjust the temperature by turning the temperature control dial clockwise or anticlockwise.
Select the desired blower speed.
NOTE
If the o
Warning display
If an abnormal condition occurs in the system, the following display/indicator
will turn on.
- ASC indicator
Warning display
Caution
► If the warning is displayed, the hill start assist will not operate. Start
off carefully.
► Park your vehicle in a safe place and stop the en
