Mitsubishi Outlander: Rear room lamp
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Rear room lamp
When replacing the bulb, put the rear room lamp switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into the notch of the lamp assembly and pry gently to remove the lens.
2. While holding down the tab (A), pull out the bulb.
3. To install the bulb, perform the removal steps in reverse.
Note
► When mounting the lens, align the tabs (B) with the holes on the vehicle body.
READ NEXT:
Cargo room lamp
When replacing the bulb, put the cargo room lamp switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the lamp assembly
SEE MORE:
Average speed
For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This
value shows the average speed (in km/h or mph) since the display was reset. If you
reset the display at the time when you want to start the measurements, average speed
from that point of time can be displayed.
Setting of door and rear hatch unlock function (vehicles equipped with the central
door lock switch)
The door and rear hatch unlock function can be set to the following two conditions.
Each time the door and rear hatch unlock function is set, a chime will sound
to tell you the condition of the door unlock function.
1. Turn the ignition switch to the “LOCK” position. If you started the eng
© 2010-2026 Copyright www.mioutlander.com
