Mitsubishi Outlander: Reference lines on the screen
Reference lines and upper surface of the rear bumper (A) are displayed on the screen.
► Red line (B) indicates approximately 50 cm behind the rear bumper.
► Two Green lines (C) indicate approximately 20 cm outside of the vehicle body.
► Short transverse lines (1 to 3) indicate distance from the rear bumper.
1- Approximately at the rear edge of the rear bumper
2- Approximately 100 cm
3- Approximately 200 cm
Note
► When the vehicle is tilting because of the number of people in the vehicle,
the weight and positioning of luggage, and/or the condition of the road surface,
the lines in the view from the rear-view camera may not be accurately positioned
relative to the actual road.
The reference lines for distance and vehicle width are based on a level, flat road
surface.
In the following cases, objects shown on the screen will appear to be farther off
then they actually are.
• When the rear of the vehicle is weighed down with the weight of passengers and luggage in the vehicle.
A- Actual objects
B- Objects shown on the screen
• When there is an upward slope at the back.
A- Actual objects
B- Objects shown on the screen
► The reference lines for distance and vehicle width are intended to indicate the distance to a flat object such as a level, flat road surface.
This may make the distance to a projecting object shown on the screen differ from the actual distance to the projecting object. Do not use them as a guide for distances to solid objects.
Example: On the screen the point B appears the nearest, then the point C and A in order of distance. The points A and B actually are the same distances from the vehicle, and the point C is farther off than the points A and B.
READ NEXT:
To change the indication on the screen of the inside rear-view mirror
It is possible to turn off the screen of the inside rearview mirror and change
the language of the warning messages on the screen.
To temporarily set the non- display mode
If you press the switc
Cargo loads precautions
Caution
► Do not load cargo or luggage higher than the top of the seatback. Be sure
that your cargo or luggage cannot move once your vehicle is moving.
Having the driver’s vision blocked,
SEE MORE:
To unlock
Press the UNLOCK switch (2). All the doors and the rear hatch will be unlocked.
If the front room lamp switch (if so equipped) is in the “DOOR” position or the
rear room lamp switch (except for vehicles equipped with the sunroof) is in the
middle (•) position at this time, the room lamp
Link System
The Link System takes overall control of the devices connected via the USB input
terminal or the Bluetooth® 2.0 interface allowing the connected devices to be operated
by using the switches in the vehicle or voice commands.
See the following section for details on how to operate.
Bluetooth®
