Mitsubishi Outlander: Seat belt inspection
(1) Check the belts for cuts, worn or frayed webbing and for cracked or deformed
metallic parts. Replace the belt assembly if defective.
(2) A dirty belt should
be cleaned with neutral detergent in warm water. After rinsing in water, let it
dry in the shade. Do not attempt to bleach or re-dye the belts because this affects
their characteristics.
WARNING
(1) All seat belt assemblies including retractors and attaching hardware
should be inspected by an authorized MITSUBISHI dealer after any collision. We recommend
that seat belt assemblies in use during a collision be replaced unless the collision
was minor and the belts show no damage and continue to operate properly.
(2) Do
not attempt to repair or replace any part of the seat belt assemblies; this work
should be done by an authorized MITSUBISHI dealer. Failure to have an authorized
MITSUBISHI dealer perform the work could reduce the effectiveness of the belts and
could result in serious injury in the event of a collision.
(3) Once the pre-tensioner
has activated, it cannot be re-used. It must be replaced together with the retractor.
(4) The entire pre-tensioner seat belt system must be inspected by an authorized
MITSUBISHI dealer.
READ NEXT:
Supplemental restraint system (SRS) - air bag
The information written in this supplemental restraint system (SRS) section contains
important points concerning the driver, front passenger, side air bags and pre-tensioner
seat belts.
The SRS a
How the supplemental restraint system works
The SRS includes the following components:
1- Air bag module (Driver) 2- Air bag module (Passenger) 3- Air bag control
unit (including the front impact sensor) 4- Seat belt pre-tensioner
5- Si
Driver’s and passenger’s front air bag system
The driver’s air bag is located under the padded cover in the middle of the steering
wheel. The front passenger air bag is contained in the instrument panel above the
glove box.
The driver ai
SEE MORE:
Fuse block
To prevent damage to the electric system due to short-circuiting or overloading,
each individual circuit is provided with a fuse. There are fuse boxes in the passenger
compartment and in the engine compartment.
The fuse box in the passenger compartment is located in front of the driver’s
Driver’s seat belt warning lamp and display
Warning lamp
A tone and warning lamp are used to remind the driver to fasten the seat belt.
If the ignition switch is turned to the “ON” position or the operation mode is
put in ON while a seat belt is not fastened, the warning lamp illuminates and the
tone sounds for about 6 seconds t
