Mitsubishi Outlander: Selection of engine oil (petrol-powered vehicle)

(1) Select engine oil of the proper SAE viscosity number according to the atmospheric
temperature. For 0W-30, 5W-30, 0W-40 and 5W-40 viscosity grade, use only ACEA A3
classification.
(2) Use engine oil conforming to the following classification:
- ACEA classification: “For service A1, A2 or A3”
- API classification: “FOR SERVICE SG” or higher
NOTE
Use of additives is not recommended since they may reduce the effectiveness
of additives already included in the engine oil. It may result in failure of the
mechanical assembly.
READ NEXT:
(1) Select engine oil of the proper SAE viscosity number according to the atmospheric
temperature. (2) Use engine oil conforming to the following classification:
Type 1:ACEA classification: “Fo
The proper amount of automatic transmission fluid is essential to the life and
operation of the automatic transmission. Either insufficient fluid or excessive
fluid could cause transmission trou
A translucent coolant reserve tank is located in the engine compartment. The
coolant level in this tank should be kept between the two marks on the reserve tank
when measured while the engine is
SEE MORE:
When the ignition switch is turned to the “ON” position or the operation mode
is put in ON, the display screen switches in the following order.
1- Screen when the ignition switch or the operation mode is OFF
2- System check screen
3- Screen when the ignition switch or the operation mode i
The fuel system should be bled to remove air as described below if the fuel supply
is exhausted during travel.
1. Undo the four clips on the air cleaner and push the cover (B) aside.
2. Press the pump (A) against the bracket (C) with your fingers until the pump
becomes stiff. Then pump sev
© 2010-2025 Copyright www.mioutlander.com
