Mitsubishi Outlander: Starting
- Tips for starting
- Starting the engine (petrol-powered vehicles)
- Starting the engine (diesel-powered vehicles)
- Using the MIVEC engine
READ NEXT:
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “LOCK”, wait a
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
υ
Starting the engine (diesel-powered vehicles)
1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
Note
► On vehicles with the Auto Stop & Go (
SEE MORE:
Instruments and controls
LHD
1. Combination headlamps and dipper switch
Turn-signal lever
Front fog lamp switch*
Rear fog lamp switch
Headlamp washer switch*
2. Instruments
3. Shift paddles*
4. Windscreen wiper and washer switch
Rear window wiper and washer switch
5. Engine switch*
6. Cruise contr
Towing
Your vehicle may be towed either by another vehicle with a rope, or by a tow
truck.
The regulations concerning towing may differ from country to country. It is recommended
that you obey the regulations of the country where you are driving your vehicle.
CAUTION
(1) In the following cases, plea
© 2010-2025 Copyright www.mioutlander.com
