Mitsubishi Outlander: Auto reset mode
► When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset.
► If the ignition switch is at “ACC” or “LOCK” for about 4 hours or longer, the average fuel consumption display is automatically reset.
Note
► The average speed display and the average fuel consumption display can be reset
individually for the auto reset mode and manual reset mode.
► “---” is displayed when the average fuel consumption cannot be measured.
► The initial (default) setting is “Auto reset mode”.
► The average fuel consumption depends on the driving condition (road condition,
driving behavior, etc.). The displayed fuel consumption may vary from the actual
fuel consumption.
Treat the fuel consumption displayed as just a rough guideline.
► The memory of the auto reset mode or manual reset mode for the average fuel consumption
display is erased if the battery is disconnected.
► The display setting can be changed to the preferred units {km/L, mpg (US), mpg
(UK) or L/100 km}.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
READ NEXT:
Momentary fuel consumption display
While driving, this displays the momentary fuel consumption, using a bar graph.
When the momentary fuel consumption surpasses the average fuel consumption, the
momentary fuel consumption is displ
Function setting screen
The “Display language”, “Temperature unit”, “Fuel consumption unit”, and “Average
fuel consumption and speed reset method” etc. settings can be modified as desired.
Refer to “Ch
Interrupt display screen (when the ignition switch is “ON”)
Warning display
When there is information to be announced, such as a system fault, a sound is
emitted and the information screen switches to the warning display screen.
Refer to the warning list a
SEE MORE:
To fasten
1. Pull the seat belt out slowly while holding the latch plate.
Note
► When the seat belts cannot be pulled out in a locked condition, pull the belts
once forcefully and then return them. After that, pull the belts out slowly once
again.
2. Insert the latch plate into the buckle until
Changing the display language
The language of the multi-information display can be switched.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lig
