Mitsubishi Outlander: Steering wheel lock
To lock
Press the engine switch to put the operation mode in OFF.
Open one of the doors.
To unlock
The following methods can be used to unlock the steering wheel.
• Put the operation mode in ACC.
• Start the engine.
CAUTION
• If the engine is stopped while driving, do not open a door or press the UNLOCK switch on the remote control switch until the vehicle stops in a safe place.
This could cause the steering wheel to lock, making it impossible to operate the vehicle.
• Carry the key with you when leaving the vehicle.
If your vehicle needs to be towed, put the operation mode in ACC to unlock the steering wheel.
NOTE
• When the following operation is performed with the operation mode in OFF, the
steering wheel is locked.
• Open or close one of the doors (except the tailgate).
• Lock all doors and the tailgate with the keyless entry system or the keyless
operation function.
• When the steering wheel does not unlock, the warning will be displayed on the information screen in the multi-information display.
Press the engine switch again while moving the steering wheel slightly.
READ NEXT:
Starting and stopping the
Tips for starting
• The operation mode can be in any mode to start the engine.
• The starter motor will be turning for up to approximately 15 seconds if the
engine switch is released at once
Using the MIVEC engine
The MIVEC engine automatically switches its intake- valve control between a low-speed
mode and a high-speed mode in accordance with driving conditions for maximum engine
performance.
NOTE
• T
If the keyless operation key is not operating properly
Insert the keyless operation key into the key slot in the glove box. Starting
the engine and changing the operation mode should now be possible.
Remove the keyless operation key from the key slot a
SEE MORE:
SRS warning lamp/display
Warning lamp
The warning lamp/display illuminates when there is a fault with the system. In
addition, the warning display will be displayed on the information screen in the
multi-information display.
Normally, when the ignition switch is turned to the “ON” position or the operation
mod
How to use the rear-view camera
When you place the gearshift lever or the selector lever in the “R” position
with the ignition switch in the “ON” position, the view behind the vehicle will
automatically appear on the screen of the MITSUBISHI Multi Communication System
(MMCS) or the inside rear-view mirror. When you m
