Mitsubishi Outlander: To install
1. Make sure the tabs (A) of the back of the wheel cover are not broken and correctly fitted on the rings (B). If in doubt, do not install the wheel cover and consult your MITSUBISHI MOTORS Authorized Service Point.
2. Align the air valve (C) of the tyre with the notch (D) in the wheel cover.
Note
► Full wheel covers have a symbol mark (E) provided on the reverse side to show
the air valve location.
Before installing the wheel cover to the wheel, make sure that the opening with
the symbol mark is correctly aligned with the air valve.
3. Push the bottom part (F) of the wheel cover into the wheel.
4. Gently push both sides (G) of the wheel cover and hold them in place with both
knees.
5. Gently tap around the circumference of the wheel cover at the top (H), then push
the wheel cover into place.
READ NEXT:
If your vehicle needs to be towed
If towing is necessary, we recommend you to have it done by your MITSUBISHI MOTORS
Authorized Service Point or a commercial tow truck service.
In the following cases, transport the vehicle using a
Towing the vehicle by a tow truck
Caution
► This vehicle must not be towed by a tow truck using sling lift type equipment
(Type A) as illustrated. Using a sling lift will damage the bumper and front end.
► Do not tow
SEE MORE:
Precautions to observe when using wipers and washers
(1) If the moving wipers become blocked by ice or other deposits on the glass,
the motor may burn out even if the wiper switch is turned to OFF. If obstruction
occurs, park your vehicle in a safe place, turn off the ignition and clean the deposits
from the glass so that the wipers operate smoo
Bonnet
To open
1. Pull the release lever towards you to unlock the bonnet.
2. Raise the bonnet while pressing the safety lock.
NOTE
• Only open the bonnet when the wipers are in the parked position. In any other
position, the wipers could damage the paint or bonnet.
3. Support the bonnet by i
