Mitsubishi Outlander: To listen to the radio

1- PWR (On-off) switch
2- VOL (Volume control) knob
3- U/M/L (UKW/MW/LW selection)
button
4- Audio adjust button
5- AUDIO button
6- TUNE/SEEK (Down-step/Down-seek)
button
7- TUNE/SEEK (Up-step/Up-seek) button
8- Memory select buttons
9- Frequency
display window
10- Preset memory number display
11- ST (Stereo) indicator
1. Press the PWR switch (1) to turn on the radio.
Press the PWR switch again
to switch it off.
2. Press the U/M/L button (3) to select the desired band (U1/U2/MW/LW).
3. Press the TUNE/SEEK button (6 or 7) or one of the memory select buttons (8) to
tune to a station.
Refer to “How to adjust the tune” or “How to enter frequencies
in the memory” on page 6–18.
READ NEXT:
VOL (Volume control)-2
Turn the knob clockwise to increase the volume.
How to adjust the tone
Press the AUDIO button (5) to select BASS TREBLE FADER BALANCE Audio adjust mode
off.
BASS (Bass t
Manual tuning
The frequency changes every time the TUNE/SEEK button (6 or 7) is pressed. Press
the button to select the desired station.
Automatic tuning
After keeping the TUNE/SEEK button (6 or
Manual setting
You can assign to the memory select buttons (8) a maximum of 12 stations in the
UKW band (6 U1 stations and 6 U2 stations), 6 stations in the MW band and 6 stations
in the LW ban
SEE MORE:
CAUTION
• Do not run the engine at high speeds (for example, by revving it or by accelerating
rapidly) immediately after starting it.
• Do not stop the engine immediately after high-speed or uphill driving. First
allow the engine to idle to give the turbocharger a chance to cool down.
Tu
When the system is in the system armed mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the doors, rear hatch or bonnet is opened
using a method other than the keyless entry system or the keyless operation function.
1. The alarm will be activated for approxim
© 2010-2025 Copyright www.mioutlander.com
