Mitsubishi Outlander: To use the external audio input function
Auxiliary Audio connector (RCA)
A- Left audio input connector (white)
B- Right audio input connector (red)
Auxiliary Video connector (RCA)
A- Left audio input connector (white)
B- Right audio input connector (red)
C- Video input connector (yellow)
You can listen to commercially available audio equipment, such as a portable audio system, from your vehicle’s speakers, by connecting the audio equipment to the audio input connectors, which are external input connectors (pin jacks).
Note
► On vehicles equipped with the MITSUBISHI Multi-Communication System (MMCS), refer to the separate owner’s manual of the MITSUBISHI Multi-Communication System.
To activate the external audio input mode
1. Use a commercially available audio cable to connect the audio equipment to the external audio input connector.
2. Press the CD button (D) for more than 2 seconds.
The display (E) will show “AUX” and then the external audio input mode will be activated.
3. To deactivate the external audio input mode, press the AM/FM button (F) or the CD button (D) to switch to another mode.
Caution
► Do not operate the connected audio equipment while driving.
This could distract you and an accident might occur.
Note
► The connected audio equipment cannot be operated with the vehicle’s audio system.
► Depending on the connected audio equipment, it may produce noise from the speakers.
► Use the connected audio equipment’s own power source, such as its battery.
Noise may be produced from the speakers if the connected audio equipment is used
while charging it using the accessory socket of the vehicle.
► Do not activate the external audio input mode when no audio equipment is connected.
Otherwise, noise may be produced from the speakers.
► Connect audio equipment when the external audio input mode is deactivated or lower
the vehicle’s speaker volume before connecting it.
Noise may be produced from the speakers if audio equipment is connected after the
external audio input mode is activated.
► For information on how to connect and operate the audio equipment, refer to the
owner’s manual for the equipment.
READ NEXT:
Steering wheel audio remote control switches
The remote control switch is located on the left side of the steering wheel.
It can be used when the ignition switch is in the “ON” or “ACC” positions.
1- Volume up button
2- Volume down
Error codes
Vehicles with LW/MW/FM digital tuning radio with CD player/CD changer
If an error code (1) appears in the display, take action in accordance with the
table below.
Error codes (iPod)
Vehicles with Link System
If an error code (1) appears in the display, take action in accordance with the
table below.
SEE MORE:
Power steering system
The power steering system operates while the engine is running. It helps reduce
the effort needed to turn the steering wheel.
The power steering system has mechanical steering capability in case the power
assist is lost. If the power assist is lost for some reason, you will still be able
to s
To enter frequencies into the memory
Manual setting
You can assign to the memory select buttons (3) a maximum of 18 stations in the
FM band (6 FM1, 6 FM2 and 6 FM3 stations) and 6 stations each in the MW and LW band.
(Stations already assigned to the memory select buttons are replaced by any newly
assigned stations.)
Follow t
